Constellation, le dépôt institutionnel de l'Université du Québec à Chicoutimi

Precipitation Characteristics of HPVDC AlSi10Mg0.3Mn Alloy Under Different Temper Conditions

Chen Zhixing, Elgallad Emad M., Liu Kun et Chen X-Grant. (2022). Precipitation Characteristics of HPVDC AlSi10Mg0.3Mn Alloy Under Different Temper Conditions. Metallography, Microstructure, and Analysis,

[img] PDF - Version acceptée
Administrateurs seulement jusqu´à 31 Mai 2023.

3MB

URL officielle: http://dx.doi.org/doi:10.1007/s13632-022-00858-7

Résumé

This work studied the precipitation characteristics of AlSi10Mg0.3Mn alloy produced by high-pressure vacuum die-casting in T5 and T6 conditions using transmission electron microscopy, differential scanning calorimetry and both electrical conductivity and microhardness measurements. Two different T6 tempers were used, involving partial solutionizing at 460 °C for 1 h and full solutionizing at 500 °C for 1 h, and were designated as T6P and T6F, respectively. The aging treatment was conducted at 185 °C for 4 h in all temper conditions. The results showed that conducting solution treatments resulted in the formation of α-Al(MnFe)Si dispersoids. In addition, Mg–Si rich precipitates formed and remained undissolved after partial solutionizing. The highest supersaturation of the α-Al was achieved in the as-fabricated (F) condition by the HPVDC process. The supersaturation degree decreased in both partial and full solutionizing conditions. TEM observations revealed different precipitation characteristics for T5, T6P and T6F tempers. β” precipitates just started to form in the T5 condition, whereas both β” and β’ precipitates completed their precipitation to different extents in the T6P and T6F conditions, resulting in different strengthening effects. The T6F temper yielded the highest microhardness followed by the T5 and T6P tempers.

Type de document:Article publié dans une revue avec comité d'évaluation
ISSN:2192-9262
Version évaluée par les pairs:Oui
Date:2022
Identifiant unique:10.1007/s13632-022-00858-7
Sujets:Sciences naturelles et génie > Génie
Sciences naturelles et génie > Génie > Génie des matériaux et génie métallurgique
Sciences naturelles et génie > Sciences appliquées
Département, module, service et unité de recherche:Départements et modules > Département des sciences appliquées > Module d'ingénierie
Mots-clés:Al-Mg-Si cast alloys, high pressure vacuum die casting, heat treatments, microstructure characterization, alliages coulés Al-Mg-Si, coulée sous vide haute pression, traitements thermiques, caractérisation de la microstructure
Déposé le:28 juin 2022 19:25
Dernière modification:28 juin 2022 19:25
Afficher les statistiques de telechargements

Éditer le document (administrateurs uniquement)

Creative Commons LicenseSauf indication contraire, les documents archivés dans Constellation sont rendus disponibles selon les termes de la licence Creative Commons "Paternité, pas d'utilisation commerciale, pas de modification" 2.5 Canada.

Bibliothèque Paul-Émile-Boulet, UQAC
555, boulevard de l'Université
Chicoutimi (Québec)  CANADA G7H 2B1
418 545-5011, poste 5630